How to keep Rabbits out of your prized perennials and veggie patch. Whether it’s Rabbits or Deer, animals in your garden can cause all kinds of trouble. Nibbled trees and ruined veg crops are a real problem. So save yourself the tears and invest in some animal-proof fencing. If you suffer from both Rabbits and Deer, combining the fencing can be more economical by reducing the number of posts required.
Rabbits in Gardens.
Rabbits are seriously bad news for gardeners, so it’s best to keep them out if possible. To do this, surround your garden with rabbit netting with a maximum hexagonal hole size of 31mm (measured vertically) and a minimum height of 0.9m above ground. Any lower and large Rabbits can jump it, so the overall height of the netting you need to buy should be a minimum of 1.05m. You can either dig a vertical trench of 150mm to bury your wire in, or you can fold 150mm wire out flat along the ground (rabbit-side), using metal netting pins to hold it down, or you can turn the turf back and hide the netting underneath. This way has advantages, as rabbits usually hop up to a fence and start digging. When they hit the wire netting just under the surface, they will stop and, hopefully, go somewhere else. If you set the wire vertically, they will dig bigger holes before realising there’s no way through.
You can attach the rabbit netting to existing fencing or a hedge for support. Alternatively, set pointed treated softwood or chestnut posts at 2 to 3 metres apart. Attach the netting with tie wire, small staples, or even plastic cable ties. Tip – Knocking in posts next to established hedges can be difficult. To make this easier, you can use metal fencing pins instead of posts. Because they are made from metal rods, they drive in much more easily between the roots. To make the netting stronger Line wires (2.5 or 3mm) can be added level with the top of the netting and just above the ground level. Clip the netting to the line wires about every 600mm with metal netting rings or cable ties.
To complete the job, check that your gates are rabbit-proof. You can easily attach netting to the back of palisade gates with staples to close the gaps. The gap under the gate needs to be no more than 25mm, you can add a timber strip to the bottom to decrease the gap if required. Don’t forget the ground directly under the gate; if it is soil, you may need to insert a 150mm-deep board so the top is level with the soil. (It should not be set above ground level as it will become a trip hazard.) Rabbits (particularly young ones) can squeeze through small gaps, so being thorough is really important and will save you a lot of heartache later on if they sneak in.
Rabbit Netting Maximum Hole Size.Measure up and call our team on 01892 864646 for a free quote. We look forward to hearing from you!
