Convex Top Diamond Privacy Lattice Panel

The convex top diamond privacy lattice has much smaller holes than our standard Crestala diamond trellis, making a denser screen that is much harder to see through. This is ideal for domestic gardens. 

• The slats used are smaller, which results in a lightweight lattice panel.
• To extend their lifespan, the panels are made from pressure-treated timber.
• These privacy lattice panels are 1.83m wide, and the sides are 30cm high.
•  This privacy lattice will fit over any standard UK panel.
• The privacy lattice is unsuitable for use where strength is important, e.g., with climbing plants.
• Due to the curved top rail, the convex top diamond privacy lattice is not easily cut down to make a part panel.
• Privacy lattice is not easy to cut down.
• Lattice strips 20mm wide x 8mm thick.
• Lattice hole side dimensions are 20-25mm.
• Stocked item.

When fitting between wooden posts, sit the trellis on top of the panel and secure it with two screws through each end batten into the posts and one screw in the centre of the bottom batten down into the panel capping.

If you are using DuraPost, then fix as with the wooden posts, except use the pre-drilled holes through the DuraPost at the ends.

For Concrete slotted posts, drop the trellis into the slots and secure with three screws through the bottom batten (centre and each end).

Retreatment may be required to keep their appearance up over time. A good quality UV oil is great for keeping these trellis looking good for longer.